MODEL SPC

Belt – 3 ply PVG (Oil resistant PVC) with 1-1/2″ high molded cleats on 12″ centers. Available in widths of 4″, 6″, 8″, 10″, 12″, 16″, 18″ and 24″.

Bed – 6-1/2″ deep x 12 gauge powder painted formed steel with 3-1/2″ high solid guard rails both sides.

Tail Pulley – 4″ diameter crowned with 1-3/16″ diameter shaft.

Overhead Drive – 10″ clearance over belt, standard.

Drive Pulley – 4″ diameter crowned and fully lagged with 1-3/16″ diameter shaft.

Belt Return – Belt is returned on smooth sheet metal slide.

Take-Up – 6″ long screws located at tail pulley to tighten belt.

Portable Supports – Heavy duty pipe support with 4″ diameter casters permit easy mobility of conveyor.

Bearings – Sealed pre-lubricated with cast iron housings.

Speed Reducer – C-Face mounted heavy duty worm gear reducer.

Motor – 1/2 HP 230/460-3-60 TE motor.

Belt Speed – 60 FPM constant.

Belt – 1⁄2″ x 1″ flat wire mesh with 1-1⁄2″ high angle cleats bolted on 12″ centers. Others.

Bed – Special bed sizes and special material such as stainless steel, galvanized, etc.

Supports – Permanent type with adjustment.

Hopper – Infeed hopper located on tail pulley end. Sized to suit application.

Motor – Single phase, energy efficient, explosion proof, etc. Other HP available.

Electrical Controls – Magnetic starters and push button stations; manual motor starters with overload protection, others.

Belt Speed – Constant and variable belt speeds available.