MODEL 350CRR

Bed – Conveying surface width 19″, 27″, 29″, 33″, 41″, 47″, 53″ and 55″. 6″ x 8.2 lb. and 8″ x 11.5 lb. powder painted structural channel frame with powder painted structural channel cross braces in each section. Sections are 5 feet long and bolted together with butt couplings and floor supports.

Tread Rollers – 3-1⁄2″ diameter x .30 wall steel tread rollers spaced on 6″ or 12″ centers, No. 80 sprockets, 1-1⁄16″ hex shaft.

Drive Chain – No. 80 roller chain.

Floor Supports – Heavy duty structural supports are fixed at 18″ elevation from floor to top of roller. One support at each end of conveyor and at each bed joint.

Center Drive – Mounted below conveyor bed section. Can be placed most anywhere in conveyor length.

Bearings – Removable, sealed, pre-lubricated ball bearings.

Chain Guard – Lower chain guard is mounted on bottom of roller frame, and upper chain guard is mounted above roller frame to totally enclose drive chain.

Speed Reducer – C-Face mounted heavy duty worm gear reducer.

Motor – 2 HP 230/460-3-60 TE motor.

Capacity – 2000 Ibs. per foot maximum.

Speed – 30 FPM constant.

Floor Supports – Lower or higher supports are available.

Side Mounted Drive – Center drive mounted to side of conveyor frame. Drive is higher than conveyor frame. Minimum elevation to top of rollers is 10-3⁄8″. Specify which side.

Rollers Set Low – Tread rollers set low in 8″ x 11.5 pound structural steel channel frame to form 1-5⁄8″ high guards.

Tread Rollers – 3-1⁄2″ diameter x .30 wall steel tread rollers spaced on 6″ or 12″ centers, No. 60 sprockets, 1-1⁄16″ hex shaft.

Drive Chain – No. 60 roller chain.

Motor – Single phase, energy efficient, explosion proof, etc. Other HP available.

Electrical Controls – Magnetic starter and push button stations; manual motor starters with overload protection, others.

Speed – Constant and variable speeds available.