MODEL 251CRRC

Bed – Conveying surface width 28″, 34″, 40″, 46″, 52″, 58″and 64″. 2-1⁄2″ diameter x 11 gauge steel tread rollers, 11⁄16″ hex shaft. Tread rollers mounted in 4″ and 6″ x 4 gauge powder painted formed steel channel frame. Sections are bolted together with butt couplings and floor supports.

Drive Chain – No. 50 circular roller chain.

Floor Supports – Heavy duty supports are adjustable 30-1⁄4″ to 40″ from floor to top of roller. One support at each end of conveyor and one center leg with knee brace.

Center Drive – Mounted underneath conveyor.

Bearings – Sealed, pre-lubricated ball bearings.

Chain Guard – Lower chain guard is mounted on bottom of roller frame, and upper chain guard is mounted above roller frame to totally enclose drive chain.

Speed Reducer – Heavy duty worm gear C-Face mounted.

Motor – 3⁄4HP 230/460-3-60 TE motor.

Speed – 30 FPM.

Capacity – 4,000 pounds distributed live load.

Floor Supports – Lower or higher supports are available. Minimum elevation, 18″ from floor to top of rollers.

Motor – Single phase,energy efficient,explosion proof,etc. Other HP available.

Side Mounted Drive – Motor reducer unit can be mounted to side of conveyor frame. Drive is higher than conveyor frame. Minimum elevation to top of rollers is 7″.

Electrical Controls – Magnetic starters and push button stations; manual motor starters with overload protection, others.

Roller Speed – Constant and variable speeds available.

Rollers Set Low – 5”deep x 4 gauge non-driven side rail to provide 3⁄4″ high guard rail.

Rollers – Tapered rollers available. Requires different size frame.